Aqua Mic Enrich’n'Seal – premium, no-sheen, enhanced-look penetrating sealer for natural stone
AQUA MIX ENRICH’N'SEALTM is a premium, no-sheen, enhanced-look penetrating sealer formulated to darken, enrich and highlight the character and beauty of unsealed natural stone. It rejuvenates the color and improves the appearance of worn and weathered stone.
May also be used as a pre-grouting sealer. Allows moisture-vapor transmission. It also effectively seals and darkens the color of grout joints.
EXPECTED WEAR:
- Will vary depending on hardness and texture of surface, type of area, surface wear, frequency, and type of maintenance products used.
- The expected wear is up to 15 years. Exterior applications may require more frequent reapplications.
- Weather conditions, harsh cleaning methods, and high-alkaline, acidic, or solvent-based cleaners will affect wear.
TEST A SMALL AREA:
According to application instructions with a 24-hour cure time to determine desired results. Test for stain repellency using likely contaminants. Once enhanced, stone cannot be restored to original color appearance.
APPLICATION:
1) Read entire label before using.
2) For new installations, sealer can be applied as soon as 48 hours after grouting.
3) Surface must be clean, dry, and free of existing sealers or coatings.
4) Apply using a sponge, brush, paint pad, cotton towel, or sprayer.
NOTE: Be sure any sealer that does not penetrate surface is polished dry off surface within 5 minutes of each application using absorbent paper or cotton towels. If non-polished surfaces are left shiny after application, surfaces must be wiped dry as this indicates surface residue remains.
5) If 2 or more coats are applied, allow a minimum of 30 minutes drying time between coats. Remove surface residue after each application.
6) Ready for surface traffic in 12 hours after final coat. Keep dry for 12 hours. Achieves full cure in 48 hours. Some highly porous surfaces may require an additional coat after full cure.
7) Clean applicator tools with mineral spirits after each use.
PRE-GROUTING APPLICATION:
Apply over clean stone or tile a minimum of 2 hours prior to grouting
- follow application procedures above.
Uses
Use on unsealed natural stone such as:
- marble,
- granite,
- slate,
- limestone,
- travertine,
- quartzite
- sandstone
- Effective for interior and exterior applications.
Where to Buy
Click here for an online supplier -> Aqua Mix Enrich’n'Seal
Online Brochure
Click here to view the official online brochure -> Enrich’n'Seal online brochure
