Aqua Mix Seal and Finish Low Sheen - stain resistant tile sealer

AQUA MIX SEAL & FINISH LOW SHEEN is a specially formulated water-based blend of acrylic polymers that provides both a stain resistant surface seal and a durable low-sheen finish eliminating conventional two-step methods. May also be used as a pre-grouting sealer. Allows moisture vapor transmission and is not affected by ultra-violet light.

Approximate Coverage:8 to 25 m2 per litre, per coat

Use on

unsealed porous surfaces such as:

• slate
• textured quarry
• saltillo
• sandstone
• terra cotta
• cement pavers
• masonry

Effective for interior and exterior applications.

EXPECTED WEAR:

• Will vary depending on hardness and texture of surface, type of area, surface wear, frequency, and type of maintenance products used.
• The expected wear is up to 3 years. Expect more frequent application on exterior areas.
• Weather conditions, harsh cleaning methods, and high-alkaline, acidic, or solvent-based cleaners will affect wear.

TEST A SMALL AREA:

According to application instructions with a 24-hour cure time to determine desired results. Test for stain repellency using likely contaminants.

APPLICATION:

1) Read entire label before using.
2) For new installations sealer can be applied as soon as 48 hours after grouting.
3) Surface must be clean, dry, and free of existing sealers and coatings.
4) Apply using a sponge or paint pad applicator. Avoid puddling.
5) If 2 or more coats are applied, allow a minimum of 30 minutes drying time between coats.
6) 2 hours after final coat conduct a test to determine if surface is completely sealed by applying water droplets to the surface. If water is absorbed, apply an additional coat. Wait 2 hours and repeat the
test.
7) Ready for surface traffic 6 hours after final coat. Keep area dry for at least 6 hours. Achieves a full cure in 24 hours.
For a high sheen finish on interior surfaces only, apply Aqua Mix Floor Shine & Hardener over Seal & Finish Low Sheen. Allow a minimum of 2 hours drying time before applying Aqua Mix finishes.
9) Clean applicator tools with water after each use.
10) May be reapplied as needed to surface that is clean and dry.

Online Brochure

Click here to view the official online brochure -> Aqua Mix Seal and Finish Low Sheen online brochure

Where to Buy

Click here to buy from an online supplier -> Aqua Mix Seal and Finish Low Sheen