Premium Natural Stone Sealer

Premium Natural Stone Sealer - Ultra Solv from Aqua Mix

AQUA MIX ULTRA-SOLV^TM is a premium, no-sheen, natural-look, solvent-based penetrating sealer formulated to provide maximum stain protection, especially in food preparation and serving areas. May also be used as a pre-grouting sealer. Allows moisture vapor transmission. It is also an excellent grout sealer.

Uses

Use on all:

natural stone (such as marble, granite, slate, travertine and limestone)
porcelain
quarry
saltillo
terra cotta
cement pavers
masonry surfaces
other porous tile and grout where a natural look is desired
Effective for interior and exterior applications.

TEST A SMALL AREA:

According to application instructions with a 24-hour cure time to determine
desired results. Test for stain repellency using likely contaminants.

APPLICATION:

1) Read entire label before using.
2) For new installations, sealer can be applied as soon as 48 hours after grouting.
3) Surface must be clean, dry, and free of existing sealers or coatings.
4) Apply using a sponge, brush, paint pad, cotton towel, or sprayer. NOTE: Be sure any sealer that does not penetrate surface is polished dry off surface within 5 minutes of each application using absorbent
paper or cotton towels.
5) If 2 or more coats are applied, allow a minimum of 30 minutes drying time between coats.
6) After 2 hours conduct a test to determine if surface is completely sealed by applying water droplets to the surface. If water is absorbed, apply an additional coat. Wait 2 hours and repeat the test.
7) Ready for surface traffic in 2 hours after final coat. Keep area dry for 12 hours. Achieves a full cure in 24 hours.
Clean applicator tools with mineral spirits after each use.

PRE-GROUTING APPLICATION:

Apply over clean stone or tile a minimum of 2 hours prior to grouting - follow application procedures above.

Premium Natural Stone Sealer - Ultra Solv from Aqua Mix